Ross openGear DAC-8416, Руководство пользователя, Страница: 21 / 32

DAC-8416 User Manual (Iss. 02) User Controls • 3–3
Configuring the DIP Switches
This section provides a brief summary of the DIP Switches of the DAC-8416. Refer to Figure 3.1
for the DIP Switch locations. Figure 3.2 shows all the DIP Switches in the OFF position.
Figure 3.2 DIP Switches — OFF Position
CAL0, CAL1 (DIP SW1 and SW2)
Use SW1 and SW2 in combination to select the analog output level of the DAC-8416. The
CAL0 Switch ( SW1 ) and CAL1 Switch ( SW2 ) are used to select the analog output level. Table 1
lists the combinations of DIP Switch settings for SW1 and SW2 .
Tone Generator (DIP SW3)
Use SW3 to enable the Tone Generator feature of the DAC-8416. This feature requires an input
signal for reference. The tone is set to 1kHz when the input sample rate is 48K, 2KHz at 96K, and
4KHz at 192K. Set
SW3 as follows:
• ON — Select this setting to enable the Tone Generator feature.
• OFF — Select this setting to disable the Tone Generator feature. This is the default
setting.
Default DIP Switch/Memory (DIP SW7)
Use SW7 to enable or disable the parameters set by the DIP Switches on the DAC-8416. Set
SW7 as follows:
• ON — Select this setting to retrieve the DAC-8416 parameters from the non-volatile
memory. The DIP Switch settings are ignored.
• OFF — Select this setting to enable the DAC-8416 to retrieve parameters from the DIP
Switches.
DashBoard Disable (DIP SW8)
Use SW8 to disable remote control of the DAC-8416 from DashBoard. Set SW8 as follows:
• ON — Select this setting to disable remote control from DashBoard. The parameters and
settings cannot be changed via DashBoard and must be changed using the card-edge
controls. You can still monitor the status of the card using DashBoard.
• OFF — Select this setting to control the DAC-8416 exclusively from DashBoard. The
card-edge controls are ignored.
Table 3.1 Setting DIP SW1 and SW2
SW1 SW2 Description
ON ON Reserved for future use
ON OFF -4dBu
OFF ON -4dBu
OFF OFF -4dBu
1 2 3 4 5 6 7 8
O N