Ross openGear DAC-8416, Руководство пользователя, Страница: 16 / 32

2–4 • Installation DAC-8416 User Manual (Iss. 02)
4.
Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
This completes the procedure for installing a Rear Module in your DFR-8300 series frame.
Installing the DAC-8416
Use the following procedure to install the DAC-8416 in a DFR-8300 series frame:
1.
Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on
page 2-3.
2.
Hold the card by the edges and carefully align the card-edges with the slots in the frame.
3.
Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4.
Verify whether your Rear Module Label is self-adhesive by checking the back of the
label for a thin wax sheet. You must remove the wax sheet before affixing the label.
5.
Affix the supplied Rear Module Label, as per the included instructions, to the BNC area
of the Rear Module.
This completes the procedure for installing the DAC-8416 in a DFR-8300 series frame.
Note
— When using the DAC-8416 with the 8320AR-036 Rear Module, ensure that
the card is installed in an even numbered slot (2, 4, 6 etc.) for a maximum of 10 cards
in the DFR-8321 series frames.