3–4 • Configuration
MB-650 User Manual (Iss. 01)
Network Configuration
The MB-650 includes an
Ethernet 10/100
port on the rear panel that is used for communication
with DashBoard and software upgrades. The exact steps for connecting to your facility via an
Automatic Configuration using DHCP
This method assumes that the MB-650 is using the factory default values for the network settings.
To establish communications with the MB-650
1.
Ensure that the MB-650 is connected to the same network as your DashBoard computer.
2.
Launch the DashBoard application on your computer.
3.
Power on the MB-650.
4.
Wait approximately 30 seconds while the MB-650 establishes network communications.
5.
Verify that the MB-650 displays in the Tree View of DashBoard.
6.
Should the MB-650 fail to display after two minutes:
• Verify the ethernet cables are properly connected.
• Check the link/activity LEDs found on the ethernet RJ-45 connector.
• Ensure the network settings for the MB-650 are set to the factory default values.
• If all cables are connected and the LEDs do not indicate an error, then automatic
configuration is not possible.
Custom User Configuration via DashBoard
Once communication has been establish with the MB-650, the network settings may be further
adjusted using the following procedure. Note that the steps are optional, you may perform as
many, or as few, as needed.
To configure the network settings via DashBoard
1.
From the
Tree View
, expand the node for the MB-650 you want to access.
2.
Select the
Network Connect
node to display the interface in the right-half of
DashBoard.The
Network
setup tab is automatically displayed.
3.
To change the
Network Time Server
address, enter the new IP Address in the
NTP
Server
field.
4.
To change between
Static
and
DHCP
addressing, select an option in the
Addressing
Mode
area.
5.
Configure the network settings as required:
•
IP Address
— This is the IP Address of the MB-650.
•
Subnet Mask
— This is the Subnet Mask address for your LAN.
•
Default Gateway
— This is the IP Address for connection outside the subnet.
6.
To save the new settings, click
Apply
in the
Network
tab. The settings are saved
immediately and take effect.
Содержание MB-650
Страница 1: ...MB 650 Monitoring Bridge User Manual...
Страница 8: ......
Страница 28: ...3 8 Configuration MB 650 User Manual Iss 01...
Страница 34: ...4 6 DashBoard Menus MB 650 User Manual Iss 01...
