Ross Master Control MC1-PANEL-16, Руководство пользователя, Страница: 12 / 58

12 • Before You Begin MC1-PANEL-16 User Guide (v4.0)
Control Panel Overview
This section provides a basic introduction to the MC1-PANEL-16, including an overview of the different areas on
the control panel.
Figure 2.2 MC1-PANEL-16 — Top View
1. Channel Selection Buttons
This area includes mnemonic buttons that allow you to toggle between multiple MC1-MK cards. Selecting a
button enables the MC1-PANEL-16 to control the selected MC1-MK card (assigned to the corresponding
channel) and displays its On Air Control interface in DashBoard.
› A lit orange button indicates that the channel is configured and available.
› A lit green button indicates the channel is selected and is active (on-air).
› A flashing green button with no other channel buttons lit indicates a loss of communication to the
MC1-PANEL-16.
› A flashing green button with other channel buttons lit orange indicates a loss of communication with the
MC1-MK card assigned to that channel. Verify that the Network Controller card housed in the same frame as
the MC1-MK card is functioning correctly.

You can quickly verify the IP address of the MC1-PANEL-16 by pressing and holding the active Channel Select
button. The IP address of the panel is reported in the Display Area.
2. Panel Control Buttons
This area includes buttons for enabling automation, and selecting a SqueezeBack preset.
›
AUTO ON
Button — Toggling this button on (button will be lit in the On Air Color) allows an Automation
System to control the MC1-PANEL-16. If this button is toggled off, the button is lit in the Panel Button Color.
Refer to the section “
Color Schemes ” on page 33 for details on selecting button colors.
›
EFFECT SEL
Button — Use this button to specify the SqueezeBack preset. Refer to the section
“ SqueezeBack Effects ” on page 39 for details.
3. Display Area with Audio Gain Control
The vacuum fluorescent display reports the channel connection status, IP connection status, the SqueezeBack
effect preset selected, and the current audio gain setting. The knob is used to control the Program audio gain, it is
set by default to 0 and has a range of -72 to +12dB. Press the knob to reset the audio gain to 0dB. You can also
1) Channel Selection Buttons 3) Display Area with Audio Gain Control 5) Keyer Area
2) Panel Control Buttons 4) Crosspoint Buses 6) Transition Area
AUTO
ON
EFF
SEL
KEY 1 KEY 2 KEY 3 KEY 4
AUDIO
OVER
KEY 1 KEY 2 KEY 3 KEY 4
SLOW MEDIUM FAST
AUDIO
OVER
BKGD
INCL
SQZ
INCL
TAKE FTB
SHIFT
SHIFT
CH3
Eff4 ONAIR GAIN: 0
PROGRAM
TRANSITION RATE TRANSITION TYPE
PRESET
PGM AO PROGRAM KEY SELECT
PRESET KEY SELECT PST AO
TRANSITION
SHIFT
SHIFT
PROGRAM
PRESET PRESET
SLOW MEDIUM FAST FTB
TRANSITION RATE TRANSITION TYPE
KEY 1 KEY 2 KEY 3 KEY 4
AUDIO
OVER
KEY 1 KEY 2 KEY 3 KEY 4
AUDIO
OVER
BKGD
INCL
SQZ
INCL
TAKE
PGM AO PROGRAM KEY SELECT
PRESET KEY SELECT PST AO
TRANSITION
FTB