Digital Indoor Aerial - Flat Panel 4G
IAFLAT-RO
User Manual
Please read this manual thoroughly before using your Ross Indoor Aerial and then retain for future reference
1.1 Important Safety Instructions:
• Please read these instructions carefully and retain for future reference. If you sell, or give this aerial
away be sure to pass on the instructions.
• There are no user serviceable parts inside this unit. DO NOT open there are dangerous voltages
inside. Electric shock hazard.
• This unit operates on AC 230V ~50Hz DC12V/50mA supply.
• During use, this device may become warm, this is normal. DO NOT allow anything to block the
ventilation slots as this may cause overheating and a consequent risk of fire.
• To be completely disconnected from the power input the power adaptor must be disconnected
from the mains.
• The marking plate is located on the bottom enclosure of the apparatus.
• DO NOT use the aerial during a thunderous day and turn off the power
• DO NOT place naked flames (such as candles) on this equipment.
• DO NOT stand other equipment on this unit.
• DO NOT obstruct the power adaptor and it should remain easily accessible during use.
• DO NOT operate close to heaters or other heat sources.
• DO NOT stand on soft furnishings
• DO NOT allow anything to trap, pinch or otherwise damage the power cord, if the power cord
should become damaged IMMEDIATELY switch the aerial off at the wall and unplug it, you should
then contact your service centre to carry out a repair.
• DO NOT overload the wall socket, this can be dangerous and lead to a fire hazard.
• MAKE SURE you have easy access to the mains plug in case of emergency.
• DO NOT unplug the unit by pulling the power cord, always grasp the plug firmly and pull from
the wall socket.
• DO NOT touch the mains plug or power cord with wet hands. Electric shock hazard.
• DO NOT stand items such as water filled cases on the aerial.
• DO NOT operate this unit in damp conditions or allow water or other fluids to enter the enclosure. If
this happens, switch off IMMEDIATELY and refer the device to the Ross helpline.
• DO NOT connect or disconnect cables from the aerial when it is turned on. Switch off the
power unit first.
• DO NOT clean this device using solvent based products. Use only a soft dry cloth.
For TVs with built-in tuner (Digital Signals)
(A) Powered via built-in tuner
(B) Powered via AC/DC adaptor
(A) Plug the antenna coaxial cable to the external
amplifier and plug the amplifiers coaxial cable
to the RF jack of your TV.
(B) Plug the antennas coaxial cable to the ANT
jack of the external amplifier and plug the
amplifiers coaxial cable to the RF jack of your
TV. Plug the power adaptors DC plug to the
DC jack of the external amplifier and the
power plug to the electrical outlet.
Option 2:
For Strong signal areas (without amplifier)
Configuration (A) Connection to the digital receiver:
Plug the antenna coaxial cable to the ANT jack of your digital receiver
Configuration (B) Connection to the
TV with built in digital tuner:
Plug the antennas coaxial cable to the RF jack of your TV
Additional notes and tips
•
If you are having major reception issues you might want to try placing the antenna
in a different position. (For example near a window)
•
You can use the antenna with or without its amplifier, depending on which connection
gives you the best signal. Using the amplifier provides the best performance in most
situations, so try using it first. If you notice that you have lost channels that you
normally receive, try connecting without the amplifier
Technical Support UK: 0845 194 7584 • Email: [email protected]