17
6.0 Advanced Installation:
This section is aimed at the more experienced Satellite Receiver (Set Top Box) user.
Speci
fi
cally, it describes how to set up your unit to work with a Motorised Dish and how to
add additional Satellites that are not present in the Factory pre-loaded list.
Press MENU to enter the INSTALLATION Menu, then use the CH-, CH+ keys to select the
item you wish to adjust and the VOL-, VOL+ to select the new setting. Then press OK to
store.
6.1 Antenna Setting
This section enables you to adjust the Receiver to match your LNB and set other
parameters for your installation.
•
LNB Type:
Select the type of LNB used with your
dish. Options are, UNIVERSAL, C BAND or NORMAL.
•
LNB Low Frequency / LNB High Frequency:
Input the LNB LOW and LNB HIGH FREQUENCY
for your LNB using the numeric keys if required.
•
22kHz Tone Control:
If the LNB frequency is not
universal, the 22 KHz should be set to “OFF”.
•
DiSEqC Control:
If your satellite receiver has been connected to a DiSEqC switch,
select the port (LNB1-LNB4) of DiSEqC or the TONE BURST A or B as appropriate.
•
Scan Mode:
Select the desired Scanning mode for the satellite; FTA only, ALL, FTA+NIT or ALL+NIT.
FTA
only:
To Search for all the Free Channels available with the selected satellite
or
transponders.
ALL:
To Search for all the Free Ch Scrambled Channels available with the
selected Satellite or Transponders.
FTA + NIT:
To Search for all the Free Channels available with the selected Satellite or
Transponders including the new transponders that are not pre-programmed in your set
top box but broadcasted by the Satellite Stream.
ALL + NIT:
To Search for ALL Channels available with the selected Satellite or Tran
sponders including the new transponders that are not pre-programmed in your set top
box but broadcasted by the Satellite Stream.