Ross GearLite TSC-9902, Руководство пользователя, Страница: 19 / 26

TSC-9902 User Guide (v5.0) Cabling • 19
Cabling
This chapter provides information on connecting the TSC-9902 to external devices.
There are three connections to the TSC-9902:
• A power supply connection to the GearLite PS-9000 power adapter
• A female BNC connection for the LTC input
• A female DB9 RS-422 serial connection

It is not necessary to terminate unused outputs.
Connecting to a Ross Production Switcher
The TSC-9902 can be used to connect an Audio Mixer to the CrossOver Solo or Carbonite Black Solo Production
Switcher. The Interface Cables are not provided by Ross Video. Refer to the user documentation for your
production switcher for details cabling to the serial port.
To connect an Audio Mixer to a Ross Production Switcher using the TSC-9902
1. Connect the TSC-9902 to the Audio Mixer as follows:
a. Connect one end of a BNC Cable to the LTC Timecode BNC port on the TSC-9902.
b. Connect the other end of the BNC Cable to an output port on the Audio Mixer .
2. Connect and secure the 9-Pin , Male end of the Interface Cable to the RS-422 Serial port on the TSC-9902
( Figure 5.1 ).
Figure 5.1 TSC-9902 Cabling — LTC Device to Production Switcher
3. Connect the TSC-9902 to a Ross Production Switcher as follows:
• Connect the other end of the Interface Cable to the EDITOR port on the CrossOver Solo Production
Switcher; or
• Connect the other end of the Interface Cable to the SERIAL port on the Carbonite Black Solo Production
Switcher. Refer to the Carbonite Black Solo Setup Manual for more information.
Refer to Table 5.1 for pinout details.
From Output on
LTC Device
POWER
LTC
SERIAL RX
SERIAL TX
DIFF
RECEIVER
MICRO
TSC-9902
L
T
C to Serial Converter
To Port
on Switcher