Ross GearLIte DAC-9213-R, Руководство пользователя, Страница: 16 / 28

15 • Configuration (Iss. 04)
Configuration
Use the Function Select switch and the Down and Up buttons to configure
the DAC-9213-R to convert SDI signals to analog component. Settings are
described in the section “
Function Setup and Configuration Menus ” on page
15. Refer to Figure 7 for switch and button locations.
Figure 7 DAC-9213-R Switch and Button Locations
General Operating Rules
Please note the following important operating rules for the DAC-9213-R:
• The module is properly powered.
• The module always powers-up in the last configuration used.
Function Selection
The factory-set default modes of operation are as follows:
• Input Video Standard = Auto Detect
• Output Video Format = YP
B
P
R
, N10 (no setup)
In general only the Output Video Format needs to be set as desired. The default
Auto-Detect input setting is extremely versatile. However, fixed mode settings
are provided for user convenience.
Function Setup and Configuration Menus
A single press of the
Down
and
Up
buttons is a “momentary” click of the
button unless indicated by “(h)”.
Table Legend
+ Press the Up button from the default position
– Press the Down button from the default position
Down Button
Function
Select Up Button
012
34
56
789AB
C
D
E