Ross GearLIte DAC-9213-R, Руководство пользователя, Страница: 14 / 28

13 • Setup (Iss. 04)
Setup
Note
— Throughout this chapter, the term SDI is used universally to
indicate either SD-SDI or HD-SDI signals.
Power Adapter and Supply
Connect the PS-9000 power adapter to the power supply connector. The
PS-9000 provides up to 2A of reg5V DC (5%). The DC power cord has
a locking connector that securely fastens into the power supply DC jack on the
DAC-9213-R. The DAC-9213-R has a standard miniature power jack (center
pin positive).
If using an adapter other than the PS-9000, ensure that:
• the polarity is correct
• the voltage is +5V DC regulated to 5%
• sufficient current for the DAC-9213-R is supplied
Caution
— Use of improper adapters may damage the DAC-9213-R
and will void the warranty.
Installations outside of North America using line voltages of 200-240V require a
plug, certified for the country of use, to be installed on the supplied line cord.
Refer to the section “
Important Regulatory and Safety Notices to Service
Personnel ” at the front of this manual for details.
Cable Connections Overview
Connect the cables to the DAC-9213-R according to the designations indicated
on the chassis label and
Figure 5 . The input is internally terminated at 75ohm. It
is not necessary to terminate unused outputs.
Figure 5 DAC-9213-R Connections
POWER
SUPPLY
SDI OUT 2 SDI IN P
B
/B OUT
SDI OUT 1
P
R
/R OUT Y/G OUT