Ross CrossOver 6, Руководство по установке, Страница: 8 / 24

Set Up for Installing the hyperSTATION Upgrade
1-2 hyperSTATION Upgrade Installation Guide
Tools Needed to Perform the Upgrade
Locate the following tools and have them ready before you begin the upgrade procedure:
• Phillips screwdriver (size #1)
• Phillips screwdriver (size #2)
• Flat Head Screwdriver
• Anti-static wrist strap (provided with Upgrade kit)
An anti-static mat is also useful. If none is available, use the anti-static packaging
provided with the hyperSTATION Upgrade kit.
Precautions and Safety Information
This section provides information intended to minimize the risk of damage to the
computer and to the upgrade kit components. Please read this section carefully before you
begin the upgrade procedure.
Component Handling Precautions
Follow these precautions when you handle the motherboard and other internal components
during the upgrade procedure:
• Make sure the power switch on the back panel of the computer is set to the off position
before you open the computer.
• Important: Be sure that the power cable for the computer is unplugged from the
computer power socket on the back of the computer. Damage may occur to the
hyperSTATION motherboard if the power cable is connected to the computer during
the motherboard installation.
• Use the disposable wrist strap provided with the upgrade kit to ensure proper
grounding during the installation procedure.
• Touch the metal casing of the computer’s power supply to discharge any static
electricity that may have accumulated on you.
• Leave the motherboard, CPU module(s) and memory SIMMs (if any) in their
protective packaging until you are ready to install them.
• Handle the motherboard by the back panel. If you must touch the circuit board, handle
it by the edges.
• Handle the ROSS hyperSPARC modules and memory SIMMs by the edges. Do not
touch the connectors.
• During installation, never force components into their slots. Excessive force can
Wrist strap