JP6
BNC7 Select
JP5
CH2
Input Select
Figure 2. Jumper Locations
Channel Mode Setup
JP5
and
JP6
configure the function of the card to operate as a single or dual channel amplifier. Use
Figure 2, the card labeling, and the following discussion to set up the card.
Dual Channel
Set
JP5
and
JP6
as follows:
•
JP5
—
IN2
(default setting).
•
JP6
—
IN2
(default setting).
Single Channel
Set
JP5
and
JP6
as follows:
•
JP5
—
IN1
•
JP6
—
OUT
Board Installation
Use the following steps to install the ADA-8503 in a RossGear 8000 series digital distribution frame:
1. Refer to the User Manual of the RossGear 8000 series frame, to ensure that the
frame is properly installed according to instructions. If this module is to be installed
in any compatible frame other than a Ross Video product, refer to the frame
manufacturer’s manual for specific instructions.
2. Please note that heat and power distribution requirements within a frame may dictate
specific slot placement of cards. Cards with many heat-producing components
should be arranged to avoid areas of excess heat build-up, particularly in frames
using convectional cooling.
3. After selecting the desired frame installation slot, hold the ADA-8503 card by the
edges and carefully align the card edges with the slots in the frame. Then fully insert
the card into the frame until the rear connection plug is properly seated.
2-2
•
Installation and Setup
ADA-8503 User Manual (Iss. 03)
Содержание ADA-8503
