Ross ADA-8405-C, Руководство пользователя

Страница: 17 / 36

ADA-8405-C User Manual (Iss. 02) Installation • 2–3
Installing the ADA-8405-C
This section outlines how to install a Rear Module in an openGear frame. The same procedure
applies regardless of the frame or card type. However, the specific Rear Module you need to
install depends on the frame you are using.
Rear Modules for the ADA-8405-C
The Rear Module for the ADA-8405-C depends on the openGear frame you are installing the
card into.
• DFR-8310 series frame — The 8310AR-042 Full Rear Module is required. The
ADA-8405-C is not compatible with the DFR-8310-BNC frames.
• DFR-8321 and OG3-FR series frames — The 8320AR-042 Full Rear Module, or the
8320AR-043 Split Rear Module can be used. When using a Full Rear Module, use the
even numbered slots, such as 2 or 4, to ensure that the card aligns with the rear module.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “ Installing the ADA-8405-C ” on
page 2-4.
To install a Rear Module in your openGear frame
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the ADA-8405-C installation.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. ( Figure 2.1 )
Figure 2.1 Rear Module Installation in an openGear Frame (ADA-8405-C not shown)
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
Screw Hole
Module Seating Slots