Ross 9259ADR-004-02, Руководство пользователя, Страница: 13 / 24

DMX-9259-A User Guide (v2.0) Hardware Overview • 13
SDI LED
The SDI LED is located on the top of the chassis (above the DIP Switches). ( Figure 3.6 )
Figure 3.6 DMX-9259-A — SDI LED
Table 3.2 describes the behavior of the SDI LED.
DIP Switches
The DMX-9259-A provides a block of four DIP switches located on the front panel, near the top. One set of DIP
switches is labeled
DMX1
and the other as
DMX2
. ( Figure 3.7 )
Figure 3.7 DMX-9259-A — DIP Switch Locations
The DIP Switches enable you to assign the group to the respective outputs. Each group consists of two AE/EBU
signals providing four channels.
For More Information on...
• setting the DIP Switches, refer to the section “ Using the DIP Switches ” on page 19.
Table 3.2 SDI LED
Status Description
Green When lit green, this LED indicates the DMX-9259-A is locked to a valid
SDI signal.
Red When lit red, this LED indicates the DMX-9259-A is not locked to a valid
SDI signal.
B GAIN
A GAIN
-+
A2
OUT
-+
A1
OUT
24-BIT
DAC
AES 4
PWR
G1-OFF/OFF
G2-OFF/ON
G3-ON/OFF
GROUP SELECT
DMX2
DMX2
DMX1
ON
G4 G3 G2 G1 SDI
SDI LED
B GAIN
A GAIN
-+
A2
OUT
-+
A1
OUT
24-BIT
DAC
AES 4
PWR
G1-OFF/OFF
G2-OFF/ON
G3-ON/OFF
GROUP SELECT
DMX2
DMX2
DMX1
ON
G4 G3 G2 G1 SDI
DIP SW 1-4