Ross 4800DR-327, Руководство по установке

Страница: 6 / 12

5 • CompactFlash Replacement
Replacing the CompactFlash
To replace the CF, you must power down the Vision control panel, remove the
CompactFlash access plate, remove the old CF, insert the new CF, and replace
the CompactFlash access plate.
Use the following procedure to replace the CF in the Vision control panel:
1. Power down the control panel. The frame can remain on during this
procedure. Refer to your Vision switcher documentation for
information on shutting down the control panel.
2. Unplug the Primary and Redundant (if installed) power from the
control panel.
Warning Hazardous Voltage
— Hazardous voltages are
present in the control panel as long as any of the power supplies
are connected to the AC power.
3.
Lift up on the control panel lid to gain access to the control panel tub.
4.
Identify the CompactFlash Access Plate on the front of the Control
Panel CPU Module ( Figure 1 ).
Figure 1 CompactFlash Access Plate — Control Panel CPU Module
5.
Remove the screws from either side of the CompactFlash Access
Plate and remove the plate from the Control Panel CPU Module.
Store the screws and CompactFlash Access Plate in a safe place.
6.
Identify the CompactFlash installed in the CF Slot on the underside
of the CPU Board ( Figure 2 ).
Figure 2 CompactFlash
Compact Flash
Access Plate
Screw Screw
PWR RST
Compact Flash