Roshults 200372, Руководство пользователя, Страница: 10 / 16

10 / 16
EN
Module Cooker Hob 50-LPG
U S E R M A N UA L
3. Turn the control knob to the “HIGH” position and press knob.
Burner should light immediately.
4. If the burner does not light in 4 seconds turn the knob off, wait 5
minutes and repeat above procedures.
Warning!
Keep your face and hands as far away from the grill as possible when
lighting it.
Warranty, Care & Maintenance
Storage
Your gas cylinder must be stored outdoors in a well ventilated area
and must be disconnected from your Cooker Hob when not in use.
Ensure that you are outdoors and away from any sources of ignition
before attempting to disconnect your gas cylinder from your Cooker
Hob. When you are using your Cooker Hob after a period of storage,
please ensure to check for gas leaks and check for any obstructions
in the burner etc. before using.
Always follow the cleaning instructions to ensure the Cooker Hob
is safe. If the Cooker Hob is stored outdoors ensure to check that
all areas under the front panel are free from any obstructions (dirt,
insects etc.) as this may affect the flow of gas. Store your Cooker
Hob in a cool dry place. It may be necessary to dry the Cooker Hob
and the inside of the cover if used
Maintenance
Maintenance is recommended after each use for your Cooker Hob,
but it is absolutely necessary to perform maintenance at least every
90 days. By doing so, you will extend the life of your Cooker Hob. Your
Cooker Hob is easy to clean with minimum effort, just follow these
helpful hints for cleaning convenience.
Prior to cleaning or maintenance, disconnect it form the gas supply
and make sure the appliance is cool. Regularly check if the pipe is on
a good state, no abrasion or broken. Do not use steam equipment to
clean the appliance, as the steam will get in to the appliance, which
can result in danger.
Cleaning of flame spreader
Remove the flame spreader from the hob for cleaning with soapy
solutions, it’s best to use a soft cloth which used for the silver
cleaning. During or after cleaning, make sure to keep the flame
spreader lid and the burner dry, and put them in the corresponding
positions. It is very important to check the right position of the flame
spreader lid, as the wrong position may result in serious damage
The Cooker Hob is made from stainless steel and aluminium. Some
parts of the frame, depending on the model, can be powder coated
on top of stainless steel material.
The easiest way to keep your Cooker Hob in a good condition we
recommend cleaning the Cooker Hob after each use.
Use lukewarm water, soap and a sponge.
• Check the sand in the drip tray regularly to ensure that it is dry
and clean. Change the sand as required (use fine-grain sand or
cat litter box sand)
Outside/frame of the Cooker Hob
• Wipe down the outside of the Cooker Hob to ensure that there
is no residual marinade or fat/grease that could corrode the
surface. Use soap and water to remove any stubborn residues.
• For cleaning powder coated surface, use a cloth or a soft
sponge.