2
1. Connecting the Router
Figure 2-1 Hardware Installation of the RNX-N360RT
Before installing the Router, make sure your PC is connected to the Internet
through the broadband service successfully. If there is any problem, please
contact your ISP. After that, please install the Router according to the following
steps. Don't forget to pull out the power plug and keep your hands dry.
1.
Power off your PC, Cable/DSL Modem, and the Router.
2.
Locate an optimum location for the Router. The best place is usually at the
center of your wireless network.
3.
Adjust the direction of the antenna. Normally, upright is a good direction.
4.
Connect the PC(s) and each Switch/Hub in your LAN to the LAN Ports on
the Router, shown in Figure 2-1. (If you have the wireless NIC and want to
use the wireless function, you can skip this step.)
