300M Wireless Router
RNX-N300RT
- 34 -
USER MANUAL
Channel -
This field determines which operating frequency will be used. The default channel
is set to
Auto
, so the AP will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
Max Tx Rate -
You can limit the maximum tx rate of the Router through this field.
Enable Wireless Router Radio -
The wireless radio of this Router can be enabled or
disabled to allow wireless stations to access. The wireless radio can only be enabled or
disabled by using the WIFI ON/OFF switch on the device.
Enable SSID Broadcast -
When wireless clients survey the local area for wireless networks
to associate with, they will detect the SSID broadcast by the Router. If you select the
Enable
SSID Broadcast
checkbox, the Wireless Router will broadcast its name (SSID) on the air.
Enable WDS Bridging -
Check this box to enable WDS. With this function, the Router can
bridge two or more Wlans. If this checkbox is selected, you will have to set the following
parameters as shown in Figure 4-17. Make sure the following settings are correct.
Figure 4-17
SSID(to be bridged)
- The SSID of the AP your Router is going to connect to as a client.
You can also use the search function to select the SSID to join.
BSSID(to be bridged)
- The BSSID of the AP your Router is going to connect to as a
client. You can also use the search function to select the BSSID to join.
Survey
- Click this button, you can search the AP which runs in the current channel.
Key type
- This option should be chosen according to the AP's security configuration. It
is recommended that the security type is the same as your AP's security type
WEP Index
- This option should be chosen if the key type is WEP(ASCII) or
WEP(HEX).It indicates the index of the WEP key.
Auth Type
- This option should be chosen if the key type is WEP(ASCII) or
WEP(HEX).It indicates the authorization type of the Root AP.
