4
User Manual
ATA-133 2 Port PCI Adaptor without RAID
RC208
3. Double click PCI Mass Storage Controller listed under Other Devices.
4. Select Driver tab, then click Update Driver button.
5. Insert the driver CD into the CD-ROM Drive and click Next.
6. Select Search for the best driver for your device(Recommended) from the following dialog
box and type D:\PCI_IO\Cmd0680\ide33 (Note: “D:\” represents the drive letter assigned
to the CD-ROM drive you are using. If D is not letter of your CD-ROM drive, substitute D
with the correct drive letter), then click Next.
7. Click Next again, then Finish.
8. Restart Windows to complete driver installation.
For Existing Windows® ME Installation
. Install the board and boot up Windows® ME.
2. At the Add New Hardware Wizard, click Next.
3. Select Search for the best driver for your device and click Next.
4. Insert the driver CD into the CD-ROM Drive and click Next.
5. Select Search for the best driver for your device(Recommended) from the following dialog
box and type D:\PCI_IO\Cmd0680\ide33 (Note: “D:\” represents the drive letter assigned
to the CD-ROM drive you are using. If D is not letter of your CD-ROM drive, substitute D
with the correct drive letter), then click Next.
6. Click Next again, then Finish.
7. Restart Windows to complete driver installation.
To Verify Windows® 98SE/ME Installation
. Right-click My Computer, then click Properties, Select Device Manager tab.
2. Double click SCSI Controllers, an entry, Silicon Image SiI 0680 ATA/33 Controller should
be listed.
3. Highlight Silicon Image SiI 0680 ATA/33 Controller and click Properties. A message this
device is working properly is displayed in the dialog box, the driver has been correctly
installed. If any error message is displayed, remove Silicon Image SiI 0680 ATA/33
Controller and restart your system.
For Windows® NT 4.0
For New Windows® NT 4.0 Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk,
copy the contents of the “PCI_IO\Cmd0680\ide33” folder, found on the driver CD, onto a
blank floppy disk then follow the directions below.
