Rosemount 5300 Series, Справочное руководство

Страница: 57 / 432

43
Reference Manual
00809-0100-4530, Rev DD
Mechanical Installation
May 2016
Mechanical Installation
Rigid single lead
1. Cut the single lead probe to the desired length. The minimum probe length is 15.7
in. (400 mm).
2. If a centering disc is used, follow the instructions on page 62 .
3. Update the transmitter configuration to the new probe length, see “Tank and
probe geometry” on page 88 and “Probe” on page 107 .
Rigid twin lead
The spacers are put closer together at the probe end. The maximum amount that can be cut
is related to the ordering length L.
Figure 3-25. Maximum Shortening
To cut a rigid twin lead probe:
1. Cut the rods to the desired length:

You may cut up to 19.7 in. (500 mm) from the probe end for probe length L
above 46.5 in. (1180 mm)

For probe length 20.5 to 46.5 in. (520 to 1180 mm) the minimum length is
20.5 in. (520 mm)

For probe length 15.7 to 20.5 in. (400 to 520 mm) the minimum length is 15.7
in. (400 mm)
2. Update the transmitter configuration to the new probe length, see “Tank and
probe geometry” on page 88 and “Probe” on page 107 .
L > 46.5 in. (1180 mm) 20.5 in. < L < 46.5 in.
(520 mm < L < 1180 mm)
Maximum
shortening length:
19.7 in. (500 mm)
L
Minimum probe length:
20.5 in. (520 mm)
L
Minimum probe length:
15.7 in. (400 mm)
L
15.7 in. < L < 20.5 in.
(400 mm < L < 520 mm)