Service mode is useful for routine inspection
and intensive cleaning of the brush assembly
area of the Rotomatic.
You should periodically inspect the consumable
items for wear and damage, such as: (Fig. 28):
1 – Black Foot x2
2 – Serrated Brake Pad
3 – White Foot x2
4 – Sealing Strip
5 – Static Brush
6 – Yellow Spray Jets x3
7 – Green Glider
If any of the above is found to be worn, damaged
or missing, then do not use your Rotomatic.
Instead call your local Rosemor machine Dealer.
More info on machine maintenance on Pg. 27
3. Operation
22/11/2019
Written and illustrated by Ben Sprules
Rosemor International Ltd 2019 ©
25
Automatic Escalator Deep Cleaning Machine – Rotomatic v1.0
3.16.1 Service Mode
It is possible also, to use the trolley to safely
gain access to the underside of the machine, this
is referred to as ‘Service Mode’.
To put the Rotomatic into service mode, first
remove both the blue plastic tanks. Next,
remove the machine from the trolley and place
it back into the trolley with the front of the
Rotomatic entering first as shown below.
From here, set the brakes on the trolley and
replace the trolley axle, press the ‘machine
down’ button to lower the front end of the
Rotomatic onto the trolley axle. Shown below.
Unplug the Rotomatic and take it by the handle
and pivot it over the trolley axle until the
Rotomatic rests on the front face of the
machine, as shown below –
Note:
It is advised to
place some cardboard (or other protective
surface) on the ground to protect the front of the
Rotomatic from damage.
1
2
3
4
5
6
7
Fig. 28 (Note: Cleaning Brushes Removed)
Always make sure the brakes
are pressed-on, on the trolley
before you attempt to put the
machine into service mode.