15
3.2 Straightening the handlebar and adjusting the steering play [Speedlifter Twist]
CAUTION
The adjusting bolt for the steering play does not serve to tighten the stem, but only to adjust the play in the steering
bearing!
1
2
5
4
3
1. Open the quick-release lever (4).
2. Press the safety lever (5) to the top and hold it in position.
3. Turn the handlebar to the direction of travel.
4. Let the safety lever (5) go and close the quick-release lever (4).
5. Check the steering bearing for play by pulling the front brake and trying to push the bike gently backwards and
forwards.
→
There must be no play.
6. If you feel any movement inside the headset:
• Turn the clamp bolt (2) on the Speedlifter (1) anti-clockwise for one to two turns.
• Use a 36 mm combination wrench to turn the adjustment ring (5) clockwise in small increments until you do no
longer notice any play.
→
After the steering head bearings have been adjusted, no more than 3 of the adjustment ring‘s (3) thread turns
should be visible. If more than 3 thread turns are visible, ask a qualified bicycle mechanic to adjust the headset
play.
• Tighten the clamp bolt (2) to a torque of 6 to 8 Nm.
7. Check the headset once again for play and repeat the previous steps, if need be, until there is no more play inside
the bearing. If in doubt, seek professional advice from a qualified bicycle mechanic.
