14
3.
Bike assembly
This chapter aims at helping you remove your bike from the ROSE bike box and re-assemble it.
Depending on the bike model, different components may have been removed or repositioned for shipping. In addition,
you have to fit the pedals and check whether your bike is in a roadworthy condition.
DANGER
Improperly installed components can cause serious crashes!
Improperly installed components may loosen during the ride!
• Always follow the installation instructions included in this manual.
• If in doubt, please consult the ROSE service or a qualified bicycle mechanic.
In addition to this manual, you will find some videos on how to assemble your bike at rosebikes.com.
Required tools
Depending on bike model and equipment, you will need the following tools for assembly:
• 4 mm, 5 mm, 6 mm, 8 mm hex wrench
• Torque wrench with a 4 mm, 5 mm, 6 mm and 8 mm hex drive
• 15 mm open-ended spanner
3.1 Opening the ROSE bike box and unpacking the contents
Before opening, check the ROSE bike box for any damages. After that, check the contents
for completeness! Please notify all possible defects immediately!
The bike box of ROSE e-bikes is designed to allow you to wheel the bike out of the box. For
this, please open the box on the small side.
1. Carefully open the ROSE bike box on one of the narrow sides. Make sure not to damage
any parts especially when using a knife.
2. Wheel the bike out of the bike box and unpack all other contents.
3. Remove – if present – any transport locking devices from the frame.
Keep hold of the ROSE bike box! You might need it to return the bike for servicing or repair.