Rose electronics CrystalView EX5, Инструкция по установке и эксплуатации

Страница: 13 / 20

CrystalView EX5 Quadro Installation and Operations Manual 9
Receiver installation
1. Locate the Receiver unit near the monitors and USB devices.
2. Connect the DVI monitor cables to the DVI-D out connectors on the
Receiver’s rear panel.
3. Connect your USB devices to the 3 USB Type A ports on the rear panel
of the Receiver. Normally these USB ports are connected to a USB
keyboard, USB mouse, and a USB Hub.
4. Connect an audio cable to the Receiver unit’s Audio port and to the
audio input port on the console sound device.
5. Connect CAT5e* cables from the Transmitter’s RJ45 connectors to the
Receiver’s RJ45 connectors.
6. Connect the supplied 5V, 3A power adapter to an AC outlet and to the
Receiver’s power port.
* CAT5 cable – It is recommended that only CAT5e or better, UTP cabling
be used to connect the Transmitter and Receiver units
together. The CAT5e cabling must have straight-through
conductors with no crossovers and terminated with 8
conductor RJ45 connectors at each end. The maximum
CAT5e cable length for a point-to-point configuration is
330 feet (100 meters).
Installation Verification
The Power, Link, Video, and USB LEDs on the Transmitter and Receiver
units will provide information regarding the installation, cabling, video, and
other items. Verify that the LEDs are registering properly (refer to Table 1
and Table 2).
If a Link LED is off, the CAT5e cable between the Transmitter and Receiver
is not connected.
The Power LED should be solid green. If it is off, the system is not ready.