Parts
Important note:
Spider Rings can be attached before or after
suspending sign. If the rings need to be posi-
tioned out of reach, or if more than two cable
wraps are required per ring, wrap the cable
around the rings before sign is hung.
Step 5
Place Spider Ring onto the cable. The cable
goes inside the ring’s outer groove.
Fig. 6
Step 6
With the cable inside the groove, wrap it once
around the ring.
Fig. 7
Step 7
While holding the ring, pull down on
cable until it pops into the groove.
Fig. 8
Repeat steps 1-3 for multiple wrappings.
Note:
Each wrap shortens the cable by 3”.
Maximum of 6 wraps or 18” per Spider Ring.
Multiple rings can be used on each cable for
more adjustability.
Step 8
Repeat steps 1-3 for each cable used to hang
your sign.
Step 9
Slide the Spider Rings up and out of view.
Fig 9
& 10. Note:
To lengthen cable, unwind one
or more wraps from each Spider Ring.
Instructions for assembly
Incept-5.02.02
The Spider Anchor and Spider Ring are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for
injury, loss or damage resulting from the use of these products.
Part #02INSSpiderRingCable&Saucer
Figure 10
Figure 8
Figure 9
Figure 6
Figure 7
Spider Ring
TM
with Cable and Saucer
Instruction Sheet
Spider Anchor
RAN-BASE-CC
Spider Ring
16-0018R
Cable and
Saucer
16-0018SS
