Parts
Step 1
Insert corner brackets into vertical
AnoFrame sides.
Fig. 1 & Fig. 2. Note:
Assembly brackets tension tabs face to-
wards outside of frames.
Split rail side is
made up of 2 separate pieces.
Step 2
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place.
Fig. 3
Step 3
Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip.
Fig. 4
Repeat steps 2
& 3 for second cable clip.
Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.
Step 4
Assemble frame following steps in.
Fig. 5
sliding sides together in the order shown.
Step 5
Insert poster.
Fig 6.
AnoFrame
TM
Instructions for assembly
Incept-9.24.02
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipBallChain
Corner
brackets
Cable Clips
06-5050
AnoFrame rails
12AF100
AnoFrame
split rails
Instruction Sheet
Figure 1
Figure 3
Figure 4
Figure 5
Figure 2
solid rail w/
solid rail
split rails
3
4
split rails
solid rail
2
1
Figure 6
Ball Chains
96-0302P