ROSE BRAND
NJ
800.223.1624
CA
800.360.5056
Install Trip Mechanism
Included with Trip Mechanism: Trip Mechanism, Mounting Bolts and Washers, Lever, Cotter Pin,
Counterweight, Mounting Lanyard, 1/8” L-Hex Key and 3/16” L-Hex Key
Step 1
: Remove the
couplings
from one side of a Kabuki unit to prep it for the
trip mechanism
. (Do this for a
second unit if a Double Kabuki is required).
Step 2
: Bolt the
trip mechanism
to the
end plate
of the Kabuki unit(s) using the four (4) bolts and washers
provided.
Step 3
: Slide the
lever
onto the
shaft
on the right side and align it with the
curtain pins
on the
curtain rod
and
pin it into place using the
cotter pin
provided.
Step 4
: Install the
counterweight
by threading the
lanyard
provided through the hole in middle of the
lever
and
hooking the
counterweight’s
quick-link onto both loop ends. Close the quick-link by tightening the nut and
allow the
counterweight
to hang down unobstructed.
Step 5
: Tie a length of tie-line to the cable protruding from the plastic cover. The length of this cord should be
as long as the curtain is tall. This is your manual release. In the event of an electrical failure, simply pull this
cord and the curtain will release.
Figure 6
Trip Mechanism
Lever
Cotter Pin
Bolts and Washers
Содержание KABUKI SYSTEM
Страница 1: ...Installation Instructions Version 1 0...
