Automotive HD Video Recorder
Automotive HD Video Recorder
4
7
PARTS IDENTIFICATION
5
4
9
11
# DESCRIPTION
IMPORTANT:
While pressing the position adjustment button, insert the recorder into the bracket,
aligning the mini USB power source in the bracket with the mini USB power slot in the recorder
1. Press & Hold Position
Adjustment Button
2. Insert the Recorder
Into the Bracket
2
1
Set Screw
Located
Behind Here
10
12
8
1. Driver Event Button
7. Status LEDs (PWR, GPS)
2. Photo Button
8. Mounting Bracket
3. Micro SD Card Slot
9. Mounting Bracket With Power Cable
4. Reset Button
10. Position Adjustment / Camera Release Button
5. Mini USB Power Slot
11. Power Cable
6. Microphone
12. Mounting Surface
6
# DESCRIPTION
3
WIRING
5
Electrical systems vary from vehicle to vehicle. Please refer to your vehicle’s manual for details
prior to installing a CYL-V recorder.
The following represents the preferred installation of CYL-V for commercial and other fleet
vehicles. The CYL-V Power Cable includes important voltage regulation and safety circuits
which are necessary for proper operation of CYL-V Recorder. NEVER use power cables other
than those supplied with CYL-V. Make sure ignition is off during installation. Wire directly to
fuse panel, do not apply piggy-back on existing hardware.
EXAMPLE:
Ground Wire
connected to the
vehicle chassis ground
1. Prepare all the parts necessary for installation.
2. Find the location of the fuse box in the vehicle. Identify
the fuses for connection of the RED POWER wire and
the YELLOW IGNITION (ACC). Identify appropriate
location for installation of the mounting bracket in
the vehicle.
3. After determining that Power Module location is
appropriate, make the following connections:
a. Connect the BLACK WIRE (GROUND -) to chassis
ground.
b. Connect the RED WIRE (POWER +) to a constant
12 V source that which will remain live after the
ignition is turned OFF.
c. Connect the YELLOW wire (IGNITION) to an ACC
power source. NOTE: it is very important to select
a connection point which has zero voltage when
the vehicle ignition turns OFF. See further details
on next page.
4. Identify approximate CYL-V Recorder location
on windshield. Confirm sufficient cable length available
to reach from windshield location to the under-dash
connection to Power Module. Remove the A-Pillar
cover and route the cable as needed.
5. Connect the mounting bracket to Power Cable.
