Rosco 296000040401, Руководство пользователя

Страница: 14 / 22

14
DMX oPeRaTIon
The Image Spot IP65 units can be ordered with a factory-installed 2m length of DMX cable that features a
water-proof gland. To set the fixture’s DMX address, you will need the Image Spot USB to RS485 Programming
Cable accessory (sold separately). Plug the USB connector into the computer running the Image Spot Addressing
Software and wire the cable’s multi-pin terminal block to the bare-ends of the fixture’s DMX cable using the
following terminal assignment:
o Terminal 1 Data + (Blue)
o Terminal 2 Data - (Orange)
o Terminal 3 Ground (White/Yellow)
1 2 3
When the fixture recognizes a valid DMX signal,
control of the unit will default to DMX. An
interruption of the DMX signal will cause the Image
Spot projector to revert to manual control, however
the last acquired output setting will be maintained.