TF 200.02.0013_eng
17
6.3 Replacement of battery
Notification!
The battery is to be replaced after 4 years at the latest.
6.4 Fault finding
6.5 Calibration of lifting columns
Lifting columns are aligned and calibrated from the factory. In case they need calibration to run
simultaneously use the
“Reset”
procedure.
7.
Environmental protection
The product is not intended to be disposed as municipal waste. Proper disassembly,
sorting and disposal of components must be done by waste disposal professionals.
Part
Disposal recommendation
Tabletop
Hard plastic or phenolic composites
Bed guards
Steel waste
Frame and wheel assembly
Steel waste
Control box
Electronics
Lifting columns
Aluminum or electronic waste
BA19 battery
Lead acid battery waste
Problem
Check the following
Mobilio does not move up or down when the hand-
control switch is pressed
1. The product is connected to 230V and the
control box LED indicator lights green
2. Motor cables are connected to control box
3. The control switch has been connected with
the control unit
4. If the product is used with battery, check
whether it is charged.
5. The motors are overloaded (note: 2 min.
ON, 18 min OFF).
Control switch defective
1. Order a new control switch
Mobilio is not horizontal / level
”Reset”
Press and hold UP ( ) and DOWN ( ) buttons.
Keep the buttons depressed until the control unit
has beeped approx. ten times. After that, the
bathtub may be adjusted to the bottom position for
resetting.
1.
