Factory settings
Page 46
RES-420
11
Factory settings
The RESISTRON temperature controller RES-420 is
configured in the factory as follows:
Up to software revision 027:
The controller can be reset with step 21 in the Configu-
ration menu:
The factory settings are restored if the "ENTER" key is
pressed. An acknowledgment message is displayed for
approximately 2s.
The language which is selected with step 20
in the Configuration menu remains set even if
the factory settings are restored.
DIP switches
for
secondary voltage
U
2
and current I
2
(Up to software
revision 027)
U
2
= 6…60VAC
I
2
= 30…100A
DIP switches:
2 ON
1, 3, 4, 5 OFF
These switches are automatically set by the AUT-
ORANGE function on all controllers as of software
revision 100.
Settings menu
No. 101 [1]
Heatsealing temperature: 0°C
No. 106 [2]
Hold mode:
OFF
No. 107 [3]
AUTOCAL temperature: 20°C
Configuration menu
No. 201 [20]
Language
German
This selection is NOT changed if the
factory settings are restored with
step 202 [21] in the Config. menu.
No. 203, 204 [22]
Alloy/range:
Alloy-20/max. 300°C
No. 206 [23]
Maximum temperature: 300°C
No. 213
Lock of „HAND“ key
OFF
No. 214 [24]
Cycle counter:
0
No. 215 [25]
Alarm relay:
Normal (contact closed by a fault)
No. 217
Temperature diagnosis: OFF
No. 218
Temp.diagnosis
delay time:
0s
No. 219
Heatup timeout:
OFF
No. 220 [26]
Measuring impulse length:Standard (1.7ms)
No. 221
Autocomp:
OFF
No. 225
Temperature unit:
Celsius
3
2
1
4 5
ON
OFF
!
