Roper Whitney 10M14-G, Руководство по эксплуатации

Страница: 13 / 85

ELECTRICAL CONNECTIONS
WARNING:
Electrical Danger -- Misuse or improper installation of machinery connected to a
source of electricity may result in accidental shock that could cause injury or death.
Installation must conform to National Electric Code (Article 250) -- Grounding, etc.
Electrical connections must be made by a trained and qualified electrician.
Electrical characteristics shown on motor plate and control panel must match the
power source; and all electrically powered equipment must be grounded.
A fusible electric "disconnect" panel box must be installed for the line incoming
three-phase electrical power. CAUTION: Motor direction must match the motor
arrow. See Figure 4, below. Switch any two single-phase leads to reverse the
motor rotation --
WARNING: Incoming three-phase electrical power must be turned
off at the fusible "disconnect" panel box before reversing leads to reverse the motor
direction.
Figure 4
MAINTENANCE
The 10M14-G shear requires a minimum maintenance schedule. The rotating
bearings are self-lubricating and require no maintenance. These are the bearings
associated with the mechanical linkage pin connections, and the bearings between
the actuator shaft and legs. The ram gib-guide bearings are made from bearing
bronze, and have grease-pockets packed with bearing grease at the Factory. These
are long-life bearings; however, if a problem occurs consult the Roper Whitney of
Rockford, Service Department. The motor gear-box is grease packed and requires
no maintenance.
CAUTION: The backgauge mechanism will require periodic oiling with standard
machine lubricating oil, as needed, to insure smooth actuating.
11