INSTALLATION PROCEDURE:
1.
Prior to installation check the length of the bath
waste is adequate to fit your bath. Also check
that your bath thickness in no larger than 10mm.
2.
Disassemble the overflow and control handle:
a.
Use a Phillips screwdriver to loosen the fixing
screw on the control handle, then slide the
control handle from the control spindle.
b.
Unscrew the overflow cover plate by turning anti-
clockwise.
c.
Fit the components to the overflow hole on the
bath in the order shown in the diagram.
d.
Fit the fixing screw so it locates in the 'V-section'
on the control spindle.
3.
Disassemble the waste section:
a.
The waste cover lifts out with the height
adjustment screw attached.
b.
The waste locking nut can be removed using a
16mm spanner or a flat head screwdriver.
c.
Fit the components to the waste hole on the bath
in the order shown in the diagram. Use a suitable
silicone sealant (not supplied) to ensure a
watertight seal is made between the waste drain
and bath.
d.
Tighten the waste locking nut by turning
clockwise.
4.
Test the waste mechanism. Turn the control
handle clockwise to raise the plug and anti-
clockwise to lower. Make any necessary
adjustments to the height adjustment screw to
alter the height the waste cover is raised (see
diagram below).
Height adjustment
Adjust height of screw
Tighten locking nut
Fixing Screw
Control Spindle
Waste Cover
Height Adjustment Screw
Waste Locking Nut
Waste Drain
Waste Washer
Control Handle
Overflow and Control Handle
Cover Plate
MAX 10mm
Overflow washer