INSTALLATION PROCEDURE
1.
Prior to installation flush out the pipe work to
remove debris & then ensure that the water supply
is turned off.
2.
Refer to diagram & check that all components
are present.
3.
Fit the flexible tail hoses to the basin mixer body
using an appropriate spanner, making sure that you
do not over tighten.
4.
Screw the threaded bar into it's location inside
the mixer body using of a flat head screwdriver to
tighten.
5.
Fit the mixer body to the basin using the
supplied rubber washer, metal bracket and fixing
nut in the order indicated in the drawing. DO NOT
over-tighten as this may damage the basin.
Remember to install the
O-ring between the mixer
body & the basin.
6.
For all models without a pop-up waste
continue to step 7. For models with a pop-up
waste see Fitting pop-up waste instructions
opposite before continuing.
7.
Connect the water supply to the flexible hoses.
Hot supply should always be connected to the left
hose (Flexible hose 1 in the diagram).
8.
Fully open the mixer on both hot & cold sides &
allow water to run for approximately one minute to
further flush the system.
9.
Check all connections to ensure there are no
leaks.
Threaded bar
Rubber washer
Metal Bracket
Fixing nut
Flexible hose 1
Flexible hose 2
Pop-up waste lever
(if supplied)
Basin mixer
(Stream model shown)
Rubber O-ring
Handle rod
Extension rod
Waste top
Rubber seal 1
Rubber seal 2
Pivot connector
Cover cap
Waste body
Handle grip
(different shape
supplied with
Express)
Pivot rod
Waste plug
M
IN
25
m
m
R
T T T
FITTING POP-UP WASTE
Insert the handle rod through the hole on the back of the basin mixer, then screw the extension rod onto the handle rod.
Fit the waste top and waste body components to the basin ensuring that Rubber seal 1 is above the basin and rubber seal 2 is below.
Slide the pivot connector onto the extension rod in the position shown in the diagram.
Place the cover cap behind the ball on the pivot rod and then insert the end of the pivot rod into the cylindrical part of the pivot
connector (do not tighten the screws on the connector block at this stage).
Insert the pivot rod through the side of the waste body so it locates through the loop on the base of the waste plug. NOTE the
position of the loop may require adjusting. Turn anti-clockwise to extend until it is long enough for the pivot
rod to be inserted through whilst sat inside the waste top.
Screw on the cover cap to lock the pivot rod in position then tighten the
screws on the pivot connector.
Test the mechanism action and make adjustments to the rod / pivot
connector positions as necessary to create a smooth action.
GENERAL NOTES
This mixer should be installed in accordance with water regulations.
Approved check valves should be fitted where required. For further
details please contact your local water authority. Should the mixer
fail to operate effectively it may be that there is insufficient water
pressure. Similarly, hot & cold water supplies should be relatively
balanced for optimum performance. A reputable plumber will be
able to advise on each of these issues.