Customer Services, Roper Rhodes Ltd, Brassmill Lane Trading
Estate, Bath, BA1 3JF
Tel:01225 303 900 | Fax: 01225 448 877
Email: [email protected] | Web: www.roperrhodes.co.uk
Installation Procedure:
Diverge Floor Mounted Unit
Installation & aftercare instructions (600mm Unit Shown for Illustration Purposes)
Please retain for future reference
600, 800 & 1000mm
Securing the unit
It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. The units can be secured through the holes in
the back upper brace. The wall plugs supplied are only suitable for solid stone/brick walls. For plasterboard walls use specialist wall plugs along with
supplementary wall strengthening as units can be very heavy. Seek advice from a specialist about the suitability of fixings to be used.
Wear suitable eye protection when drilling. Take care when using power tools near water - the use of a residual current device (RCD) is
recommended. Beware of hidden pipes or cables. Take care when drilling tiled surfaces as the drill might slip. Use a piece of masking tape to prevent
the drill from wandering.
RR-DIVFM REV : 21.07.2014
Drawing 1
Drawing 2
Door Hinge Adjustment
Hinges may require adjustment for correct door alignment. This is achieved with the adjustable soft close hinges using the
adjustment screws A, B and D (see Drawing 1). To access these you will first have to remove the screw cap cover. The hinges also
feature a quick release mechanism to quickly and easily detach the door from the furniture frame, this is activated by pressing
button C (see Drawing 1).
1.
2.
To make adjustment 1 (see Drawing 1)
tighten/loosen adjustment screw A.
To make adjustment 2 (see Drawing 1)
simply turn screw B
To make adjustment 3 (see Drawing 1)
unscrew screws D. Move doors into
correct position and re-fix
Button C is the quick release, press this
on both hinges to remove a door by
releasing the hinges from their
mounting plates.
2
2
Door
Furniture frame
C
B
A
1
1
Drawer Fascia Adjustment
To make adjustment 1 (Up and Down) turn screw A (see drawing 4)
To make adjustment 2 (Left and Right) turn screw B (see drawing 4)
Rotate plastic cover.
Fascias may require adjustment for correct alignment. If adjustment is required follow instructions below.
A
B
2
2
1
1
3
4
D
D
3
3
