ROOTS RootsScrub B6050, Руководство пользователя

Страница: 12 / 22

12
RootsScrub B6050, B6050C Dom & Exp
OPERATION BRUSH
Installation of brush
Disc Type
The brush must snap in immediately. A rattling
noise indicates that the brush head is not
correctly centered. Turn off switch ”A”, correct
position of brush head and turn on switch “C
(B6050 & 6050C)” or “D (B6050x)” for locking.
Now the brush is locked. Repeat locking
operation.
Installation of brush
Ÿ
Remove screw of the brush cover.
Ÿ
Fasten supplied brushes at the drive rollers at the
inside of the opposite cover.
Ÿ
Close brush cover such that the guiding rollers and
the brushes catch safely.
When mounting, check the safe catching of
rollers and brushes.
Before cleaning or maintaining the machine as
well as before replacing parts of it, turn the
machine off and disconnect the plug.
Cylindrical Type
Brush Lifting
Ÿ
Pedal is used to lift and lower the brush.
Ÿ
For lowering, first press the pedal a little to outside
(unlock) and then allow it to move slowly upwards.
Ÿ
For lifting, press the pedal slowly downwards and
make it lock.
Brushes / Pads
The machine must be equipped with brushes from the
accessories kit, as required by the degree of dirtiness
and kind of ground.
Ÿ
The tank should be empty.
Ÿ
Lift the squeegee.
Ÿ
Place the brush in front of the machine.
Ÿ
Raise the brush head.
Ÿ
Move the brush to center of the brush head.
Ÿ
Lower the brush head so that the catch is centered in
the brush.
Ÿ
For B6050 - Turn on switch “B” for a short time in
order to allow locking.
Ÿ
For B6050x - Turn on switch “C” for a short time in
order to allow locking.
When lowering the machine pay attention to
prevent the pedal for lifting of the brush head
from being pressed down.
Removal of brush
Ÿ
Empty the tanks.
Ÿ
Lift the squeegee and the brush
head.
Ÿ
For B6050 - Press switch “D1 &
D2” simultaneously for unlocking
of brush.
Ÿ
For B6050x - Press switch “B & E”
simultaneously for unlocking of
brush.
Debris Cleaning
Ÿ
Tilt the debris tray towards machine side and pull it
out.
Ÿ
Now empty the tray by inverting it and shaking.
Ÿ
Clean the tray and place it back for further cleaning
Ÿ
Press the rear end of the machine downwards.
Ÿ
Pull the machine towards the rear.
Ÿ
Brush is now lying in front of the machine.
Pedal to
raise/lower
the brush
Removal of brush
Ÿ
Raise the brush head and set to its parking position.
Remove the screw at the idler end, open the cover
and pull the brushes towards the user.
Ÿ
Close the cover and retighten the screw.
When inserting the brushes for the next
operation, make sure to change position of the
brush such that one-sided brush wearing is
preluded.