USER MANUAL
7
the water inlet of the washer. The supply hose must have an internal
diameter of at least 13mm (1/2 in) and must be reinforced. the water
supply must be at least equal to the washer delivery capacity.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds to
allow air to escape and discharge residual pressure in the hose.
- Keeping the trigger pressed push the switch to start the motor.
- When re-starting the motor, always keep the trigger pressed.
NOTE:
THE MOTOR ONLY RUNS WHEN THE TRIGGER IS OPERATED.
CORRECT USE OF STANDARD ACCESSORIES
- The washer is equipped with adjustable nozzle.
- Jet adjustment from pencil to fan.
WARNING!
DO NOT ADJUST THE NOZZLE WHILE THE TRIGGER IS SQUEEZED.
RECOMMENDED CLEANINIG PROCEDURE
- Dissolve dirt by applying detergent with the fan jet to the dry surface.
on vertical surfaces, work from the bottom upwards. leave the detergent
to act for 1 to 2 minutes, but do not allow to dry out. Apply the high from
the surface, working from the bottom upwards.
- Avoid allowing the rinsing water to run on to unwanted surfaces.