4
※
Adjustment
The desired pattern, volume of fluid output and fine atomization can easily be obtained by regulating
the Pattern Adjusting Knob, Fluid Adjusting Knob and Air Adjusting Knob.
①
Adjusting pattern:
Turning Pattern Adjusting Knob to the right until tight will make spray pattern
round, or turning it left, will make spray pattern ellipse.
②
Adjusting volume of fluid output:
Turn the Fluid Adjusting Knob, clockwise will reduce the
volume of fluid output and counter-clockwise will increase fluid output.
③
Adjusting air volume:
Turning the Air Adjusting valve clockwise will reduce the air volume. And
counter-clockwise will increase the air volume.
※
Maintenance
Pour remaining paint into other container and then clean paint passage and air cap. Spray a small
amount thinner to clean passage. Incomplete cleaning will cause adverse pattern sharp and particles.
Clean other sections with attached brush, soaked with thinner soft clothes.
※
Caution
Never use the wire or other hard thing to dig nozzle, fluid needle, this will cause the damage of them.
Never immerse spray gun completely in thinner or solvent. When reassembly, always clean parts to
prevent the sticking of dust.
※
Troubleshooting
The following chart lists common issues and solutions.Please read it carefully and follow all instructions
closely.
WARNING!
Potential hazard that could result in serious injury or loss of life
.
If any of the following symptoms appear while the tool is in use, turn it off and disconnect it from the
air supply immediately. Failure to heed this warning could result in serious personal injury.
Disconnect the electrical plug and air supply from the tool before making any adjustments.
Repairs must be performed by a qualified service technician only.
2
3
1
