10
A hose, hose assembly, and spray gun assembly shall be constructed to provide electrical bonding to dissipate static
electricity from the tip of the Spray gun through the spray gun assembly and the couplings at the ends of the hose to
the pump assembly. The spray gun assembly shall also provide an external means to dissipate static electricity
during the cleaning process when spraying into a metal container.
Construction
Black hose is constructed of an extruded, seamless themoplastic inner tube, chemically bonded to multi-layers of
high tensile synthetic resistant polyurethane cover. A static drain element of flexible, electrically conductive material
is located between the braid layers.
FEATURES
·Polyurethane cover permits greater flexibility and tighter bends
·Resistant to flex fatigue
·Dissipates static charge
·Will not swell or degrade in contact with most paint chemicals, oils and most other solvents
·Light weight- approximately half that of comparable rubber or wire hose
·O.D smaller than comparable rubber hose without reducing the I.D., pressure rating, or fluid-carrying capacity
·Highly abrasion resistant
·Extrmely durable
Pressure Relief Procedure
Follow this
Pressure Relief Procedure
whenever you are instructed to relieve pressure, stop spraying, check or
service equipment or install or clean spray tip.
1. Turn OFF power and turn pressure control to lowest pressure setting.
2. Hold gun against side of grounded metal flushing pail. Trigger gun to relieve pressure.
3.
Turn prime valve down.
Our pressure relief should by operate by hand.
