Ronde & Schwarz R&S FPL1000, Руководство пользователя

Страница: 567 / 1076

Network and Remote Operation
R&S
®
FPL1000
567 User Manual 1178.3370.02 ─ 09
Bit No. Meaning
6 - 7 Unused
8 "CALibration"
This bit is set if the R&S FPL1000 is unaligned ("UNCAL" display)
9 "LIMit" (device-specific)
This bit is set if a limit value is violated in any of the active channels in any window.
The STATus:QUEStionable:LIMit Register provides more information on the error type.
10 "LMARgin" (device-specific)
This bit is set if a margin is violated in any of the active channels in any window.
The STATus:QUEStionable:LMARgin Register provides more information on the error type.
11 "SYNC" (device-specific)
This bit is set if the R&S FPL1000 is not synchronized to the signal that is applied.
The R&S FPL1000 is not synchronized if:
●
it cannot synchronize to midamble during a measurement or premeasurement
●
it cannot find a burst during a measurement or premeasurement
●
the results deviate too much from the expected value during premeasurements
12 "ACPLimit" (device-specific)
This bit is set if a limit during ACLR measurements is violated in any of the active channels.
The STATus:QUEStionable:ACPLimit Register provides more information on the error type.
13-14 Unused
15 This bit is always 0.
STATus:QUEStionable:ACPLimit Register
Available for the Spectrum application.
The STATus:QUEStionable:ACPLimit register contains information about the results of
a limit check during ACLR measurements. A separate ACPLimit register exists for
each active channel.
You can read out the register with
STATus:QUEStionable:ACPLimit:CONDition?
or
STATus:QUEStionable:ACPLimit[:EVENt]?
Table 10-10: Meaning of the bits used in the STATus:QUEStionable:ACPLimit register
Bit No. Meaning
0 ADJ UPPer FAIL
This bit is set if the limit is exceeded in the upper adjacent channel
1 ADJ LOWer FAIL
This bit is set if the limit is exceeded in the lower adjacent channel.
2 ALT1 UPPer FAIL
This bit is set if the limit is exceeded in the upper 1st alternate channel.
3 ALT1 LOWer FAIL
This bit is set if the limit is exceeded in the lower 1st alternate channel.
Remote Control Basics