Ronde & Schwarz R&S FPL1000, Руководство пользователя

Страница: 341 / 1076

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
341 User Manual 1178.3370.02 ─ 09
Additionally, a delay time can be defined so that the first few measurement points after
the gate opening are ignored.
To indicate that a gate is used for the sweep, "GAT" and the gate source is displayed in
the channel bar.
7.7.2.2 Gate Settings
Access : "Overview" > "Trigger" > "Trigger / Gate Config." > "Gate Settings"
Gate settings define one or more extracts of the signal to be measured.
Gating is not available for measurements on I/Q-based data.
Gated Trigger .............................................................................................................. 341
Gate Mode .................................................................................................................. 341
Gate Delay .................................................................................................................. 342
Gate Length ................................................................................................................ 342
Gated Trigger
Switches gated triggering on or off.
If the gate is switched on, a gate signal applied to one of the TRIGGER INPUT connec-
tors or the internal IF power detector controls the sweep.
Remote command:
[SENSe:]SWEep:EGATe
on page 786
Gate Mode
Sets the gate mode.
For more information see Chapter 7.7.2.1, "Gated Measurements" , on page 340
Remote command:
[SENSe:]SWEep:EGATe:TYPE
on page 788
Trigger and Gate Configuration