Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 609 / 1071

Remote Commands
R&S
®
FPL1000
609 User Manual 1178.3370.02 ─ 11
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel setup.
Setting parameters:
<ChannelName1> String containing the name of the channel setup you want to
rename.
<ChannelName2> String containing the new channel setup name.
Note that you cannot assign an existing channel setup name to
a new channel setup; this will cause an error.
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
Example: INST:REN 'IQAnalyzer2','IQAnalyzer3'
Renames the channel setup with the name 'IQAnalyzer2' to
'IQAnalyzer3'.
Usage: Setting only
Manual operation: See "Changing the Channel Setup Name" on page 64
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel setup with the defined channel setup type, or
selects an existing channel setup with the specified name.
Also see
●
INSTrument:CREate[:NEW]
on page 607
Parameters:
<ChannelType> Channel type of the new channel setup.
For a list of available channel setup types see
INSTrument:
LIST?
on page 608.
<ChannelName> String containing the name of the channel setup.
Example: INST IQ
INST 'MyIQSpectrum'
Selects the channel setup named 'MyIQSpectrum' (for example
before executing further commands for that channel setup).
Manual operation: See "Spectrum" on page 80
See "I/Q Analyzer" on page 80
See "AM FM PM Analog Demod" on page 80
See "Noise Figure" on page 80
See "Phase Noise" on page 80
See "Vector Signal Analysis (VSA)" on page 81
See "Defining a channel setup" on page 82
See "New Channel Setup" on page 83
Selecting the Operating Mode and Application