Ronde & Schwarz 1304.0004K03, Руководство пользователя

Страница: 528 / 1071

General Instrument Setup
R&S
®
FPL1000
528 User Manual 1178.3370.02 ─ 11
NONE ..........................................................................................................................528
Calibration Frequency RF ........................................................................................... 528
└ Frequency ..................................................................................................... 528
Calibration Frequency MW ..........................................................................................528
NONE
Uses the current RF signal at the input, i.e. no calibration signal (default).
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 953
Calibration Frequency RF
Uses the internal calibration signal as the RF input signal.
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 953
DIAGnostic:SERVice:INPut:PULSed:CFRequency
on page 953
Frequency ← Calibration Frequency RF
Defines the frequency of the internal broadband calibration signal to be used for IF fil-
ter calibration (max. 64
MHz).
Calibration Frequency MW
Uses the microwave calibration signal as the RF input. This function is used to cali-
brate the YIG-filter on the microwave converter. The microwave calibration signal is
pulsed. The microwave calibration signal frequency is fixed at 1.5
GHz.
Remote command:
DIAGnostic:SERVice:INPut[:SELect]
on page 953
Service Functions