The Spectrum Application (RF Measurements)
R&S
®
FPL1000
431
User Manual 1178.3370.02 ─ 11
Storing and Recalling Limit Lines
Limit lines can be stored with the configuration settings so they can be recalled for
other measurements at a later time (see
Chapter 7.2, "Storing and Recalling Instrument
Settings and Measurement Data"
on page 464). Note, however, that any changes
made to the limit lines
after
storing the configuration file cannot be restored and will be
overwritten by the stored values when the configuration file is recalled. Always remem-
ber to store the settings again after changing the limit line values.
After recalling measurement settings, the limit line values applied to the measurement
may be different to those displayed in the "Limit Lines" dialog box; see
recalling transducer and limit line settings"
6.11.2.2
Limit Line Settings and Functions
Access
: "Overview" > "Analysis" > "Lines"
or
: [LINES] > "Line Config"
Up to 8 limit lines can be displayed simultaneously in the R&S
FPL1000. Many more
can be stored on the instrument.
Stored limit line settings
When storing and recalling limit line settings, consider the information provided in
ing and recalling transducer and limit line settings"
.........................................................................................431
Limit Line Management
Access
: "Overview" > "Analysis" > "Lines" > "Limit Lines"
or
: [LINES] > "Line Config" > "Limit Lines"
Display and Limit Lines
