Ronde & Schwarz 1304.0004.03, Руководство пользователя

Страница: 139 / 1076

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
139 User Manual 1178.3370.02 ─ 09
Channel Bandwidth ..................................................................................................... 139
Channel Spacings ....................................................................................................... 139
Limit Check ................................................................................................................. 140
Weighting Filters ..........................................................................................................141
Channel Names .......................................................................................................... 141
Channel Bandwidth
The Tx channel bandwidth is normally defined by the transmission standard.
The correct bandwidth is set automatically for the selected standard. The bandwidth for
each channel is indicated by a colored bar in the display.
The value entered for any Tx channel is automatically also defined for all subsequent
Tx channels. Thus, only enter one value if all Tx channels have the same bandwidth.
The value entered for any ADJ or ALT channel is automatically also defined for all
alternate (ALT) channels. Thus, only enter one value if all adjacent channels have the
same bandwidth.
Remote command:
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>]
on page 641
[SENSe:]POWer:ACHannel:BANDwidth:ACHannel
on page 641
[SENSe:]POWer:ACHannel:BANDwidth:ALTernate<ch>
on page 641
Channel Spacings
Channel spacings are normally defined by the transmission standard but can be
changed.
Measurements and Results