Ronan Engineering X96SI/R, Инструкция по эксплуатации

Страница: 93 / 136

Output Problem
Follow these steps to troubleshoot output problems.
Access the Outputs Group, Output Percent for the output-in-question.
1. Is the Output Percent correct?
– If yes, check the analog output board
– If no, make sure the Get Output Form for this output is pointing to the menu variable
you wish to use as the gauge’s output.
2. Make sure the Output Low Range is the lowest value you expect (represents zero percent
output).
3. ‹!H"'%}"'&"'V%Z!'%%%'!""|&'&'^^&-
cent output).
4. Is the output percent correct?
– If no, check the analog output board.
– If yes, you are done.
Analog Input
Follow these steps to troubleshoot problems with the Analog Inputs:
1. Access the I/O Status menus and display the address for the Analog Input module.
2. Is the Analog Input module found?
– If no, the module was not found.
– If yes, proceed to the next step.
3. Is the Type (mA/V) correct?
– If no, remove the module from the rack, set the switch to the proper input (mA/V), and
retry the modeul.
– If yes, proceed to the next step.
4. ‡'%"BJ¤
– If no, press the setup button (or reset button if failed then the setup button), and then
press the continue button. Proceed to the next step.
– If yes, press the reset button and see if the module was found.
5. Remove the wiring from pins 5 and 6, hook a voltage or current source (depending on the
switch setting), to pins 5 and 6, and monitor the input value on the handheld.
6. Is the value displayed okay?
– If no, try calibrating the analog input module. If the calibration fails or the input still does
not work, replace the analog input module.
‡B?%H'%+"&&'%'!ˆ"'#
93