OPERATING INSTRUCTIONS
When pressure is applied to a coloured circle the corresponding colour will be activated on the
ROMPA® Wi Fi receiving product(s) in the room e.g. light source, colour wall controller etc.
A firm press is necessary on the circle. The colour will not be activated unless the circle is pressed
– pressing anywhere else on the bumpa will not activate the corresponding coloured light.
The light cast by the colour wall controller will remain on the selected colour until someone
presses another circle. Should no-one press another circle, after one minute, the colour
wall controller will revert to its automatic cycle – the light will scroll through a sequence of
colours. In other words, the bumpas have a ‘latched’ operation – the colour stays on for
one minute unless another circle is activated.
14.
Care and Maintenance
Fabric Care
Always supervise the use of the product.
Organise a regular cleaning schedule.
Vinyl will crack, tear and rub off if subjected to sharp objects or continual rubbing by hard
objects. Remove shoes, and avoid buckles, zips or sharp/hard/pointed objects coming into
contact with the surface.
Check seams regularly to ensure that these are not worn or split and the interior filling
cannot be accessed.
Wipe off accidental marks/liquids at the time they occur or are noticed.
From time to time, if possible, lift floor cushion or move furniture to clean all surfaces
and the floor underneath.
Avoid eating and drinking whilst using these products.
Steam cleaning is not recommended.
Do not place near sources of heat or fire that may damage the surface (radiators, fires,
underfloor heating, hot central heating pipes etc.)
Direct contact with bright sunlight may affect material over time.
Do not saturate the material with lots of water.
PVC (Vinyl)
Use a soft brush remove all loose dust/dirt
Clean with a mild detergent (such as Lux soap flakes in luke-warm solution) applied to a
sponge or damp cloth.
This may be sanitised using a weak solution of Milton fluid.
Do not use excessive amounts of water and always ensure the PVC is dry after cleaning.
Do not use an abrasive cleaning pad.
Do not use boiling/very hot water, washing up liquid / aggressive detergent or solvent
based cleaner as this will cause the coating to discolour and go hard.
Steam cleaning is not advised.
