12.
Technical Specification
Size:
202L x 66.5W x 9cmH
Working load: 113kg (250lbs)
13.
Installation
Please check equipment immediately for any damage that may have resulted during
shipping. If any damage has occurred, please contact ROMPA® immediately.
1.
Attach the top platform piece to the slide ramp piece.
2.
You will need a 4mm (5/32”) allen key (not included) to tighten your screw sets.
Place the open end of the screw pair on the inside of the ramp, and screw in the
threaded piece from the outside. Repeat for all six holes.
3.
Double-check that all hardware is securely tightened before use (first use and every
use).
4.
Make sure that the unit you are attaching the Scooter Board Attachment to (e.g.
21554 Climb and Go – Set of 2 or a wall-mounted frame intended for balance beams,
PE equipment etc of a comparable weight) is on a flat and level surface. Attach the
Scooter Board Attachment to the desired rung by hooking both the top platform end
hooks securely over the rung.
