Page
3
of
18
Copyright ROMPA® Ltd
INFINITY & BEYOND 20565, KH 4.11
TO WALL MOUNT PANEL
IMPORTANT
: This panel weighs approximately 21 kg. Please take this into consideration
when fixing. Please make sure that you are aware of the construction of the wall the panel is
to be fixed to. Taking this into account please ensure that you use the correct fittings.
1. Attach fixings such as mirror plates to the back of the panel. Fixings are not supplied as
these depend on the surface the panel will be fixed to. Check the fixings e.g. mirror plates
you buy can easily support 21kg. You may wish to attach two mirror plates to the back of
the panel at the top and two on the back at the bottom.
Note
: When attaching fixings to the back of the panel please proceed with caution – be aware
that there are electrical assemblies inside the panel.
TO OPERATE
1. Plug in to mains supply. Switch on using the rocker switch at the top of the panel. The
display will light up immediately.
2. Connect the Removable Control Box to the socket on the top of the panel – this will be
located near to the switches shown above.
3. Connect the One Button Switch Box to the jack socket on the lower half of the panel as
required. Another compatible simple switch could be connected to this jack socket e.g.
Soft Koosh Switch 19966.
3. There are four buttons on the Control Box. These have the following functions:
Red button with a swirl – pattern selection
There are 49 LED effects to choose from.
These are:
1. All the LEDs in both circles are illuminated and the colours rotate (2 LEDs at a time) in
sequence, showing full circles. The display is multi-coloured - red, green, blue and
purple. The rotation is clockwise.
2. All the LEDs in both circles are illuminated, showing full circles. The display is red only.
The LEDs appear to rotate.
3. All the LEDs in both circles are illuminated, showing full circles. The display is green only.
The LEDS appear to rotate.