Important Note
Only ROMPA
®
switches should be used in conjunction with the Fireworks Panel. Radios,
amplifiers or other equipment terminated in jack plugs should never be connected to the jack
socket for the switch. Damage to the electronics of either or both items is likely to f ollow.
SWITCH OFF and UNPLUG after use.
WI FI ACTIVATION
The display can be controlled by a Wi Fi ‘controller’ – see ‘Compatible ROMPA® products’
above, and please refer to the separate instructions for these products.
14.
Care and Maintenance
Switch off and unplug before cleaning and maintenance.
Wipe the exterior of the Panel with a clean, soft and very slightly dampened cloth.
Avoid abrasive cleaning products, bleach, solvents etc. Do not allow the Panel to
become wet.
Do not strike the Panel – handle it with appropriate care.
In the unlikely event of problems, only a suitably qualified person should attempt
repair.
This panel contains LEDs so it is highly unlikely that any lamps will need to be changed.
There is no need to access the inside of this panel. Please do not remove the cover.
15.
Troubleshooting
Problem:
The panel does not light up?
Ensure that the panel is plugged in and switched on
Check the 5 Amp fuse inside the UK plug
Problem:
Crackling noise
Make sure there are no mobile phones nearby as they can cause interference.
If the crackling noise is intermittent, this may be one of the sound effects. If it is
constant, please contact us to discuss a replacement control board.
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received – please contact us at
FIREWORKS PANEL 18544, February 2016
Copyri ght ROMPA® Ltd
