20.
Speak into the microphone to activate the vibration.
21.
Adjust the controls to control the vibration.
14.
Care and Maintenance
Switch off components individually before unplugging from the mains.
First, make sure all the controls are set to their lowest settings. Then switch the
amplifier off BEFORE unplugging. Failure to do so may blow the fuses.
Do not allow the Vibrating Floor to become wet.
Do not strike the Vibrating Floor – use it with appropriate care.
15.
Troubleshooting
The Vibrating Floor does not work
In the event of product failure check the connections (as detailed
in ‘Installation’ above).
If product still fails to operate, check the fuses. These are
located in the UK plug of the Amplifier and below the ON/OFF
switch on the Oscillator. Switch off and unplug before checking.
Constant noise
When the oscillator is in use there is a noise produced associated
with the vibrations. This is unavoidable as vibrations are
produced through the speakers. If noise is still present in stereo
mode, the oscillator may have been left on at the same time.
Avoid this by removing the lead with paired RCA connectors on
the end that connect the oscillator and the amplifier.
No noise
Make sure that the amplifier has not been turned right down to the minimum setting
– turn up as required.
High pitch squealing noise
Make sure the BASS control is not set to the maximum – turn this down.
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received – please contact us at
VIBRATING FLOOR 14925, March 2018
Copyright ROMPA® Ltd
